How about the quotation of TPE material suppliers in Beijing?

TPE is processed by overmolding injection,

Diene transparent TPE, diene TPE is mainly an isomer of natural rubber, so it is also called thermoplastic trans natural rubber. Although its heat resistance and mechanical strength are not as good as rubber, it is widely used in shoemaking, sponges, optical films, and other industrial rubber products due to its good transparency, weather resistance, electrical insulation, and photodegradability.

Transparent TPE is used in appliance casings, handles, grips, etc. It exhibits a very good hand feel, is anti-slip and labor-saving, and is easy to color and process. It also has a wide range of design possibilities.

TPE material supplier

Common products include handles, grips, electronic materials, etc. The material gives the products a comfortable touch, improves grip, enhances product appearance and added value.

TPE overmolding generally uses a two-shot injection molding process, where the molded hard plastic part is fixed in the overmolding mold,

The transparent grade is divided into transparent and translucent series, each with various hardness levels; excellent transparency; smooth and soft surface; good anti-yellowing performance, tear resistance, good tensile strength; meets environmental requirements; suitable for various transparent series products.

Due to the high light transmittance required for transparent TPE materials, the surface quality of the material products must be strict, without any defects such as streaks, bubbles, whitening, haze, black spots, discoloration, poor gloss, etc. Therefore, throughout the entire injection molding process, special attention and strict or even special requirements must be paid to the TPE raw materials, equipment, molds, and even product design.

TPE material supplier

Then the TPE soft material is injection overmolded onto the hard part at an appropriate temperature, and the product is obtained after cooling. The injection temperature for overmolding varies depending on the hard plastic material being overmolded.

When using a regular injection molding machine for two-shot overmolding on nylon, it is recommended that before overmolding,

The transparent grade is divided into transparent and translucent series, each with various hardness levels; excellent transparency; smooth and soft surface; good anti-yellowing performance, tear resistance, good tensile strength; meets environmental requirements; suitable for various transparent series products.

Transparent TPE is used in appliance casings, handles, grips, etc. It exhibits a very good hand feel, is anti-slip and labor-saving, and is easy to color and process. It also has a wide range of design possibilities.

TPE material supplier

First, preheat and bake the nylon part, because nylon has strong water absorption, and overmolding requires a higher molding temperature; preheating before overmolding can remove moisture, facilitating quick hot overmolding.